
Boat Covers
Sterns Orion ™ Deluxe Trailerable Boat Cover

Orion boat covers are specially engineered for the rigors of highway
travel trailer towing and outdoor high winds storage.
- Quick-release buckle and strap system for easy fitting and trailering
- Storage bag and all trailering straps included
- Tension panel system holds cover tight and distributes stress from high
winds and highway speeds
- Special pocket to store strap and prevent damage
- Rear cinch cam buckles lets you cinch the bottom hem tightly to your boat
- Full cut to allow extra room for accessories such as bow rails,
running lights, etc.
- Dual rear air vents reduce inside moisture and ballooning of cover at high
speeds
- Rugged Orion™ Deluxe Marine Canvas won’t stretch or shrink and is stronger
than the cotton canvas used in most boat covers
- Fabric coating technology assures maximum water resistance and water
repellency
- Resistant to mildew and U.V. damage
- Color is blue and grey
- Four year warranty
|
Model AA |
Fits: 12' to 14' (beam width to 68"):
V-Hull Fishing Boats |
Part # 83008 |
$88.90 |
|
Model A |
Fits: 14' to 16' (beam width to 75"):
V-Hull Fishing Boats |
Part # 83018
|
$97.90 |
|
Model B |
Fits: 14' to 16' (beam width to 90"):
V-Hull Runabouts (outboards and I/O)
Tri-Hull Runabouts (outboards and I/O)
Aluminum Bass Boats
|
Part # 83028
|
$114.90 |
|
Model C |
Fits: 16' to 18.5' (beam width to 98"):
Fish and Ski Boats
Pro-Style Bass Boats
|
Part # 83038
|
$134.90 |
|
Model D |
Fits: 17' to 19' (beam width to 102"):
V-Hull Runabouts (outboards and I/O)
|
Part # 83048 |
$138.90 |
|
Model E |
Fits: 20' to 22' (beam width to 106"):
V-Hull Runabouts (outboards and I/O)
|
Part # 83058 |
$165.90 |

Installation Instructions: Orion ™ Deluxe Boat Cover
- Cover sharp points (such as windshield corners) with cloth or sponge tape
to avoid stressing or tearing your boat cover.
- Drape your cover over your boat with the tapered end marked FRONT at the
bow.
- Pull your cover below the rub rail around the entire boat the end of the
buckle opposite the toothed end). Then tighten the strap on the other side.
- Your cover includes quick release straps that secure your cover to your
boat. There are long straps with clips on two ends and three short straps that
have a clip on one end and a loop on the other. Locate the shortest strap with
the looped end. Push the loop through the bow eye on your boat, run the clip
end of the strap through the strap loop, and clip the strap into the socket
above on your cover.
- Locate the remaining two straps with looped ends, these are for the stern.
Secure the looped end of each strap to your trailer or boat and clip into the
corresponding cover socket above.
- The hem below the rub rail of your cover tightens with two cam buckles at
the stern. (They are covered by a fabric flap.) Tighten one of the two straps
exiting the cambuckles by pulling it away from the toothed side of the buckle.
(To loosen the strap press down the end of the buckle opposite the toothed
end.) Then tighten the strap on the other side. Repeat until the bottom
of your cover is snug against the hull.
- The remaining long straps secure the sides of your cover. To attach a
strap clip one end into a socket sewn on your cover. Toss the unconnected end
of the strap under your boat then connect the end to the corresponding socket
on the opposite side of your cover.
- After attaching ALL of the straps tighten all the straps so that your
cover is snug and even across your boat. Reattach the protective cover over
the stern cam buckles.

Notes: Before driving / towing, check that all straps are tight and
firmly attached. After driving a couple of miles, it’s a good idea to recheck
your boat cover. Be sure your cover is completely dry before you store it for
any extended period.
Care And Cleaning
If your boat cover becomes dirty, it can be cleaned with lukewarm water and a
soft brush. DO NOT USE SOAP on your Orion Cover - it can damage the protective coatings on the
canvas fabric.
Sterns Hurricane ™ Pontoon Boat Cover

Our best pontoon boat cover for indoor or outdoor storage.
- Fits all popular pontoon boats with three sizes
- Rope attaches to rugged non-scratch D-rings. No grommets to pull out or
scratch
- Adjustable transom flap for a superb fit
- Tie down rope and two stern fit elastic cords included
- Elastic cord sewn into entire bottom hem provides a tight and custom fit
- Tough polyester Hurricane ™ fabric won’t shrink, won’t stretch and is much
stronger than ordinary cotton canvas
- Resistant to mildew and U.V. damage
- Color is blue
- Four year warranty
|
Model AP |
Fits: 17' to 20' Pontoon Boats
(beam width to 96") |
Part # 89418 |
$228.90 |
|
Model BP |
Fits: 21' to 24' Pontoon Boats
(beam width to 96") |
Part # 89428 |
$255.90 |
|
Model CP |
Fits: 25' to 28' Pontoon Boats
(beam width to 96") |
Part # 89438 |
$287.90 |
Note: The above Hurricane pontoon boat covers are designed for use
while storing your boat. Do not use it for trailer towing or transportation.
Towing your boat on the highway with the cover installed will void your
warranty.

Also Available:
Class 1, 2 and 3 Trailer Hitches

|
Order Toll Free: 1-888-425-2885 Sales Dept. / Accessory Tech. Help:
1-216-441-9120
Fax: 1-216-441-9127
Phone Support Hours EST:
Monday thru
Friday 9:00am to 6:00pm
Saturday 10:30am to 2:00pm |
|
Automotive Accessories Connection Inc.
5161 Warner Road
Garfield Heights, Ohio 44125

E - mail:
sales@accessconnect.com
|
Your car, truck, van and suv
accessories dealer on the web since 1996
Anything on our web site is quoted in US government
dollars.
Currency converter
Quantity discounts available. Please contact our
sales staff at: 1-216-441-9120
|


Copyright: 1996, 1997, 1998, 1999, 2000
2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008
|